After 30 minutes of trying, took a break and searched for ideas on how to do it. Now the hard part - in that limited space, how the F do you get that clip back on? Yeah, you have to compress the cap to expose the grove for it, but now have to figure out how to get the retainer to actually go in. Pull the goodies out, transfer the parts to the new servos (lots of vasoline to hold the bottom spring in place because when you have right side jacked up it tends to slide off) and install.
The solution was a pry bar to compress the cap into the tranny and while doing that, pop the clip out. Took me 15 min to figure out how to get retainer clip off. Got right side jacked up as far as it can go and jack stands installed.
The problem is where that sucker is located and the limited working space. You reuse your pin, two springs, a washer and a clip. For those fearing tackling this, just get the full servo kit from betperformance.
0 kommentar(er)
